10
5.
Advanced Setup
For most users, the settings in "WiFi" and "VPN" sections are enough. The "Advanced" setup is rarely
needed. You will get a warning message on accessing "Advanced" UI page.
Figure 12 Advanced Settings
By default, the hotspot LAN is 192.168.10.0/24. And you should stick to this setting. Only if the wireless
uplink happens to be 192.168.10.0/24 should you change this setting.
To change hotspot LAN
, click "192.168.10.0". The "10" part then becomes editable. Input your new
value and hit "Enter" on your keyboard to commit the change.
To change hotspot network name
, click "vpneveryone.ddns.net". Then it becomes editable. Input your
new value and hit "Enter" on your keyboard to commit the change.
To change web UI password
, click "********". Then it becomes editable. Input your new value and hit
"Enter" on your keyboard to commit the change.
In all three cases above, if you change your mind in the middle of change, click the left part to cancel the
change. e.g. Clicking "
Hotspot Name
" before you hit "Enter" on your keyboard would cancel the change
and the original value is restored.
You rarely need to reboot USB dongle via UI. You can reboot USB dongle by pulling USB connector and
plug it back in.
You rarely need a factory default reset. Only if you think you mis-configure something and don't know
where it is, you may factory default it.
