Installing your Tonearm and Aligning the Cartridge
VPI Turntables are available with Uni-pivot or Gimbal tonearms. This manual covers the
procedures for installing a Gimbal as it is the standard stock option.
To avoid injury, do not touch the male pivot point. It is extremely sharp.
(Note: the parts are the same/similar and apply for standard and Fatboy Gimbal as well)
Installing and Aligning the Cartridge
●
For cartridges with threaded mounting holes, use the screws supplied by the cartridge
manufacturer. Other screws may not fit properly and may cause damage to the threads
and cartridge.
●
To avoid damage to the 3D tonearm, use the provided finger lift which also serves as a
washer supplied by VPI under the screw heads and do not tighten the screws too tight.
●
For cartridges with pass-through mounting holes, use the hardware supplied with the
tonearm. Be sure to use washers under the screw heads.
●
It is recommended to use the Vertical Tracking Alignment (VTA) base to raise and lower your
arm.
●
The arm should be placed in the arm rest when you are not playing a record.
