Page 8
Menu Settings
Remote Control
The settings menu can only be accessed by using the remote control as
described below.
Enter picture menu
Menu Down
Guide line up
Guide line left
Enter guide line adjustment
Guide line clockwise
Guide line counter clockwise
Menu Up
Guide line right
Guide line down
Display View Control
Menu Setting Operation
In the “full display screen” mode, short press the
button to enter
the menu and advance through the available settings. The
and
buttons are used to change the setting value.
Example: If the brightness setting must be adjusted, Press the
button
until Brightness is displayed. Then Press the
or
buttons to set the
proper brightness level.
“Wire CTR Delay” Setting
This setting will control the functionality of the wired remote control.
• If “WIRE CTR DELAY” is set to “OFF”, the wired remote control will have
the same function as the “CH” button on the mirror control.
• If “WIRE CTR DELAY’’ is set to any other value (eg. 5, 10), The wired
dash control will cycle though the camera views and switch back to
full screen mode after the selected timer expiries.
Note
: The timer begins after the last press of the wired remote control.
Video Delay Setting
This setting will control the delay timer of the input triggers. This feature
will ensure that the video input will remain on the screen until the turn
signal is deactivated. The default setting is ten (10) seconds.
To adjust the Video Delay Setting:
Press the
button until Video Delay is displayed. Then Press the
or
buttons to set the proper delay timer needed.
