Page 7
Note:
This system has a built-in delay timer that can be set to prevent
the video input from flashing ON/OFF with the vehicle’s turn signal pulse.
This feature will ensure that the video input will remain on the screen
until the turn signal is deactivated. The default setting is ten (10) seconds.
Reference “Menu Settings on page 8 for more information.
Trigger Inputs:
• Pink - Video 2 (Left) Trigger Input: Connect this wire to the vehicle’s left
turn signal wire. This wire will test as a Positive (+) pulse while the left
turn signal is engaged.
• Purple - Video 3 (Right) Trigger Input: Connect this wire to the vehicle’s
right turn signal wire. This wire will test as a Positive (+) pulse while the
right turn signal is engaged.
• Green - Video 4 (Reverse) Trigger Input: Connect this wire to the
vehicle’s reverse signal wire. This wire will test Positive (+) while the
vehicle is in reverse gear.
System Layout
Power / Ground Inputs:
The Red and Black wires are the main power supply for the mirror system.
This system may operate using a maximum of two amps (2A) of current.
Be sure to connect this to a vehicle circuit that can handle the additional
power requirement.
Red
- Accessory 12-Volt (+): Connect this the vehicle’s main accessory
circuit. This wire will test 12-Volt (+) when the key is in the accessory and
ignition positions.
Black
- Ground: Connect this wire to the vehicle’s chassis ground. If
possible this wire should be connected to a factory grounding location. If
one is not available this wire should be attached to the vehicle’s chassis
using a screw to make a secure connection.