8812 Module
Cover Control Module
Cover Control Module Owner’s
Manual (R1.00)
PAGE-4
GOVERNMENT REGULATIONS
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesirable operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television, which can be
determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.
To satisfy FCC RF exposure compliance requirements, the device and its antenna must maintain a separation distance of 20 cm
or more from the person’s body, except for the hand
and wrists, to satisfy RF exposure compliance.
WARNING!
Changes or modifications not expressly approved by VOXX Electronics. could avoid user's authority to operate the
equipment.
This device complies with Industry Canada license-exempt RSS-247 standards. Operation is subject to the following two
conditions:
1.
This device may not cause interference, and
2.
This device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standards RSS-247. Son fonctionnement est soumis aux deux
conditions suivantes:
1.
Cet appareil ne doit pas provoquer d'interférences et
2.
Cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de
l'appareil.”
Health Canada RF Exposure Warning:
This device complies with Health Canada’s Safety Code. The installer of this device should ensure that RF radiation is not em
itted
in excess of the Heath Canada’s requirement. The device must maintain a separation distance of 20cm or more from the person’s
body, except for the hands and wrists. Information can be obtained at:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-eng.php
Lignes Directrices de Santé Canada sur l’exposition aux radiofréquences:
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le
programme d’installation de cet appareil doit s’assurer que
les rayonnements RF n’est pas émis au
-
delà des limites établies par Santé Canada. L’emplacement de l'appareil doit se situer à
une distance de 20cm ou plus par rapport au corps de la personne, à l
’exception des mains et des poignets. Les informations
peuvent être obtenues à l’adresse Internet suivante:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-fra.php
