3
2020 Voxx Electronics Corporation. All rights reserved.
Using Your Remote Control
Door Unlock
While the engine is running press, and release and hold the
button or three
(3) seconds. Unlock is only available while the vehicle is remote started.
Remote Starting Your Vehicle
To activate the remote start, press and release the
button two (2) times. The
vehicle will start and run the predetermined time set up during installation (5 to
60 minutes selectable).
Remote Start Shutdown
Press and release the
button two times to turn the vehicle off. Pressing the
vehicle’s brake will also shutdown the remote start.
Entering the Vehicle while it is Running via Remote Start (Optional)
1.
Unlock the vehicle’s doors.
2.
Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3.
Insert the key into the ignition switch and turn to the ON or RUN
position.
4.
Press the brake pedal. The remote starter will disengage and the
vehicle will operate normally.
NOTE:
This feature may not be available on all vehicle makes/models. In some
vehicle applications the remote start will shut down upon entering the vehicle
and the engine will stop running. For these applications it will be necessary to
restart the vehicle normally. Refer to installing dealer for details.
Preheating or Precooling the Vehicle’s interior
Before exiting the vehicle, set the temperature controls to the desired setting
and operation. After the system starts the vehicle, the heater or air conditioner
will activate and heat or cool the vehicle’s interior to your setting.
Remote Start Service Mode
For safety, the remote start feature can be disabled to prevent accidental
starting while the vehicle is being serviced.
To engage Remote Start Service Mode
1.
Press and hold the valet button.
2.
Cycle the vehicle’s ignition ON/OFF three (3) times.
3.
Release the valet button.
The LED will begin to flash two (2) short flashes followed by one (1) long flash
to indicate Remote Start Service Mode is active. Repeat steps 1-3 above to
disengage Service Mode.
