10
8. Repeat the above test, but this time move the gear selector to the drive position. If the system attempts
to start, failing this test, check the Violet wire connection. This wire must be connected to the
ignition switch side of the Neutral saftey switch. If the vehicle you are working on does not have an
electrical Neutral Safety switch, it will be necessary to reconfigure the Remote Start wiring to
accommodate this vehicle.
COMPLETING THE INSTALLATION:
1. If you have not done so already, place the red rubber handle cover over the handle of the control switch
for ease of identification. This will allow your customer to distinguish the Remote Start control switch from
the program switch.
2. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain
that the mounting location will not inhibit any of the controls of the vehicle.
3. Securely tie all wiring up and away from all hot and moving parts that they may come in contact with under
the dash board or in the engine compartment areas.
CAUTION
:
Avoid the area around the steering shaft and column, as wires can wrap around these
mechanisms and inhibit the safe operation of the vehicle.
4. Apply the Caution labels supplied with this kit to a conspicuous area in the engine compartment. Make
sure to clean the surface before affixing the label.
5. Check the vehicle's wipers, lights, horn, etc.... to insure proper operation.
6. Replace all panels that were removed during installation, and retest the system.
7. Explain all activated features and safety systems associated with Remote Start system installed to the
customer.
8. Place the Remote Start Control Switch Tag on their respective switch and point these out to the customer.
Summary of Contents for CA-420
Page 13: ......
