OPERATION
~ 15 ~
˙
Pressing the ESC key exits the current screen.
˙
To view a different BANK, pressing the PAGE UP key goes to a previous BANK, while
the PAGE DOWN key brings you to the next BANK.
˙
Once you have selected a computer on the menu, press ENTER to switch to that port.
˙
Pressing the TAB key opens up the Function menu. In this menu, you can select the
SCAN TIME and DISPLAY TIME.
NOTE
: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are
set on the MASTER unit only, and need not be set on the slave units.
The Bank/SCAN Button:
Pressing the Bank/SCAN button cycles you through all the active BANKs (if there are
slave units present) and then puts the unit in AutoScan mode. If the unit is a single
MASTER unit, pressing the button immediately invokes AutoScan mode. This is evident
by a long beep, followed by two short beeps.
SCAN TIME:
Amount of time the KVM08 stays one port
before switching to the next port when in
Scan Mode
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection
SCAN TIME:
DISPLAY TIME:
7sec
15sec
30sec
60sec
7sec
15sec
30sec
60sec
[ ]: SELECT
(INS): RENAME
(Enter): COMPLETE
(Esc): Exit
