VOX electronics WK-1308, Instruction Manual

Page: 3 / 62

20. To protect from electrical hazard, do
not immerse the kettle, power base or
cord set in any liquid.
21. The kettle is only to be used with
the stand provided.
22. To protect against fire, do not
operated in the presence of
explosive and/or flammable fumes.
23. The appliance must not be immersed
in water.
24. This product is not designed for any
other uses other than those specified
in this booklet.
25. This appliance is intended to be
used in household only.
26. Save these instructions for
further reference.
27. Never let the kettle operate while
unattended.
28. Switch off the power supply and discon-
nect from mains supply when not in use,
before cleaning or other maintenance.
29. Never touch the hot parts of the
appliance.
30. Steam will cause burn. Be careful
when opening the lid with hot water.
31. Always turn off and unplug the
kettle when it is not in use.
32. Avoid using an extension cord,
extension cord may cause risk of fire
because of overheat.
Before first use
Before first use, fill the kettle with clean water to maximum capacity and boil.
Discard the water and repeat the process.
Operation
1. The kettle should always be unplugged
when filling or adding water.
2. Fill the kettle with water to desired lev-
el. Do not overfill or there will be a risk
of spillage or spitting. The water level
indicator will assist you to measure the
correct amount. You can fill the kettle
via the spout or after opening the lid. Do
not forget to close the lid after filling;
otherwise the kettle will not automati-
cally switch off after use.
3. Do not fill with less than 0.5 litres of
water
tШΝ“mТЧ”ΝТЧНТМatТШЧ
to prevent
the kettle running dry while operating.
4. Do not fill with more than liter of
water
tШΝ“maб”ΝТЧНТМatТШЧ
.
5. An automatic safety cut-out has been
fitted for protection against overheating;
it will operate if the kettle is switched
on when containing insufficient
water. Always ensure the water
inside the kettle covers the minimum
mark on the water level indicator
gauge. If the automatic safety cut-out
has operated, switch the kettle off,
disconnect from the power outlet and
allow the kettle to cool down for 5 to
10 minutes. The refill with and switch
on, the kettle will work as normal.
6. Place the power base on a dry, flat
surface. Place the kettle on the power
base. The electrical connection will be
made automatically as the kettle
slides onto the power base.
7. Plug the cord set into an earthed
power socket and switch on by
pressing the on/off switch of the
kОttlОΝtШΝtСОΝ“ШЧ”ΝpШsТtТШЧέΝ
3