User Name: no default, maximum length
47
characters
Password: no default, maximum length
35
characters
Service Name (optional): no default, maximum length
47
characters
Close Connection when Idle Time Over (second): default
0
, range
0
to
4294967295
PPPoE with Fixed IP Address: default
DISABLE
If you subscribe a DSL service with PPPoE connection from ISP, you can set IP configuration to PPPoE to get a
dynamic IP address. Your ISP will provide you the
User Name
and
Password
, some ISP will also need the
Service Name
to authenticate. But this item is optional and depending on your ISP.
If you want to keep the connection always on between UT-6301 and your ISP, then set the value of item
Close
Connection When Idle
Time Over
to 0, otherwise, when the idle time of no any traffic on line is over the setting
value, UT-6301 will terminate this PPPoE connection.
If your ISP can provide you fixed IP address when PPPoE connection established each time, you can select
PPPoE with Fixed IP Address
as ENABLE and enter the IP address given from ISP.
3.3 Serial Type
The UT-6301 support three serial types: RS232, RS422 and RS485, These types are listed in the drop-down
menu for the Serial Type setting. Each setup screen and available features will differ depending on what kind of
Serial Types you select and UT-6301 product model you buy. Default is RS232
RS232
Baud Rate: default
115200
, range 1200bps to 230.4Kbps
Data Bits: 5, 6, 7,
8
(default)
Parity Check:
None
(default), even, odd
Stop Bits:
1
(default), 2
Flow Control:
None
(default), CTS/RTS (or Hardware), XON/XOFF (or Software)
Force Packet Transmit Time (ms): default
40
, range
20
to
65535
The timing of transmitting an Ethernet packet, in order to get the whole data in on packet, you can tune this
setting value to fit the data length of your device per transmission. The more small value be set will get more
less data in one packet.
- 15 -
