Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Fig 1
Fig 2
Fig 3
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Insert the flat screw driver
into the buckle groove and
remove the top cover
The flat screw driver should be
no more than 3mm in size
3mm
Insert the flat screw driver
into the buckle groove and
remove the top cover
The flat screw driver should be
no more than 3mm in size
3mm
Press the tab with
flat screw driver
Snap together
M4x25mm screw
M4x20mm screw
M4x25mm screw
M4x20mm screw
ST 2.9x9.5mm screws
ST 2.9x16mm screws
Button up the top
1. Remove the top cover using flat driving(Fig1)
2. Connected the top cover with the canopy using the screws
(Supplied) .(Fig2)
3. Feed AC supply wire through top cover and canopy center hole,
snap top cover and the fixture together.(Fig3)
4. Assemble canopy onto Junction box with screws (supplied) and make
proper wire connections.Black Wire (L); White Wire (N);(Fig4)
5. Use screws (supplied) to tighten canopy to mounting plate (spider
plate/cross bar)(Fig5)
6. The unit can be installed on any surface, you may rotate the
Acrylic panel in any angle from 0 degrees to 180 degrees.(Fig5)
1. Remove the top cover scerw driver and remove the end cap.
using a flat screw Pull out the wires through the side.(Fig1)
2. Snap the top cover into the fixture.(Fig2)
3. Pullout all AC supply wires and feed the wires through the holes of
end cap and then canopy.(Fig3)
4. Assemble canopy and end cap to metal bracket with screws (supplied)
and make proper wire connections.(Fig4)
5. Using screws (supplied) tighten canopy to spider plate (crossbar).
(Fig5)
6. The unit can be installed on any surface, you may rotate the
+Acrylic panel in any angle from 0 degree to 180 degree. (Fig1)
1. Remove the button(Fig1.Fig2)
2. Change to desired pictogram(Fig3)
3. Reinstall buttons and snap them together together(Fig4)
AC ON TEST
AC ON TEST
AC ON TEST
AC ON TEST
WALL SIDE MOUNT
CHANGING OR REPLACING PICTOGRAM
WALL MOUNT
AC ON TEST
AC ON TEST
AC ON
TEST
AC ON TES
T
Fig 4
