VOSS IEP770RF, User Manual

Page: 33 / 40

2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
10.4 Catalysis
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Clean the inner glass of the oven door
with warm water and a soft cloth.
Remove all accessories.
The cavity is caoted with catalytic
enamel. It gathers fat and dirt which
burns off at high temperatures without
leaving a smell.
To support this self-cleaning process
heat the empty oven regularly.
Spots or discolouration of
the catalytic surface have no
effect on its catalytic
properties.
1. Set the function .
The display shows CATA and the
duration of the cleaning procedure (1
hour). You cannot change the duration,
but you can use the End function to
delay the start of the cleaning procedure.
A signal sounds after the time ends. The
oven turns off.
2. Push the button to stop the signal.
3. Clean the bottom of the oven with a
damp soft sponge.
To stop Catalysis before it finishes, turn
the knob for the oven functions to the off
position.
10.5
Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
• if you press and at the
same time.
10.6 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
A
A
3. Close the door until it is at an angle
of approximately 45°.
ENGLISH 33