22
85285 - 07.2021 - V5
INSTRUCTION MANUAL VOSS.FARMING EASYCUT
7.4 CHANGING BLADES
A blade set consists of an upper blade and a larger,
lower blade, the grinding sides of which always rest
on each other.
CAUTION
Keep your fingers away from the sharp edges
of the blades to avoid injury.
1.
Switch off the clipper and disconnect it from the
power supply.
2. To release the tension on the blades, turn the
tensioning nut (2).
The blades are loosened.
3. Turn the clipper over and place the clipper on a
flat, stable surface.
The fixing screws (7) are at the top.
4.
Loosen the fixing screws (7) using the enclosed
tool (fig. 3).
NOTICE
Do not remove the fixing screws (7) completely.
You can remove the old blades.
5.
Make sure that the new blades, especially the
grinding sides, are free of dirt.
6. Insert the upper blade into the guide points of the
oscillating head.
7.
Oil its grinding surfaces with the oil supplied (fig. 4).
7.3 OILING BLADES
Oiling your machine is essential for a good result. It
also prevents overheating and significantly extends
the life of the blades and the machine. Therefore, a
thin film of oil must be applied to the moving parts
of the head.
CAUTION
Keep your fingers away from the sharp edges
of the blades to avoid injury.
To oil the blades during use, drip the oil onto the
shearing blades and into the opening every 10
minutes (fig. 2).
NOTICE
►
Make sure that the shearing blades do not run dry.
►
Only use special clipper oil for oiling.
Fig. 2
Fig. 3
Fig. 4
Notice
:
oil every 10
minutes
