Vortice VORT QBK - SAL KC Series, Instruction Booklet

Page: 15 / 32

Handling
Before moving the product, make sure that the
equipment being used has an adequate lifting
capacity.
Use a fork lift truck and pallet to lift the appliance.
Alternativly, it’s possible to lift the appliance with
harness, as shown in fig.3.
The product can be lifted manually in agreement with
the applicable legislation.
The weight of each model is shown in the following
table.
ATTENTION !!!! The mounting feets are not supplied
Installation
Before beginning installation, make sure that:
• the platform where the appliance is to be positioned
is both flat and smooth and capable of safely
bearing its weight.
• the power supply matches the characteristics
shown on the ID plate.
• the area where the appliance is to be positioned
offers enough room for installation and later
maintenance work. There must be enough room on
the inspection panel side of the appliance for the
panels to be fully opened and for components to be
removed should the need arise.
The appliance must be installed in such a way that
the shaft of the motor runs parallel to the ground.
The product has to be installed with drain device
located on the base.
Inspection lid can be placed on left, right or top side
depending of the needs.
A minimum ground clearance of 100mm is required
for access to the drainage point.
The appliance is statically and dynamically balanced
to level 6.3 according to ISO 1940 standards,
however the use of vibration dampers on the base is
possible.
15
3 3
Kg
VORT QBK-SAL KC 315 33
VORT QBK-SAL KC 355 50
VORT QBK-SAL KC 400 68
VORT QBK-SAL KC 500
80
VORT QBK-SAL KC 560 100
ENGLISH
mm. 100
4 4