7
ENGLISH
Description
The product that you just purchased is a wall mounted centrifugal aspirator ideal
for medium , small residential and commercial spaces , equipped with a brushless
low consumption motor.
The product is also equipped with timer PCB that alert (with a red led ON) the user
when a filter needs to be replaced or cleaned: This PCB is powered by a buffer
battery CR2032 ( with a duration of 2 years , then it needs to be replaced) . On the
first start up it’s necessary to remove a little plastic tab from the zone shown in (Fig.
11) and press as show in (Fig.10) to turn the led off and reset the timer.
Installation
1) Remove the protection grid A) from flange B) after loosening the screws D)
(Fig. 1)
2) Remove flange B)from the motor support C) after loosening the screws H)
(Fig. 1-2).
3) Fit the nozzle M) (Ø 100) or N) (Ø 120) on the motor support C) close to the
delivery hole using the screws provided in the accessories bag (Fig. 3-4)
4) Install the motor support C) next to the delivery hole using the screw anchors
provided in the accessories bag (Fig. 5)
5) Perform the electric connections (Fig. 6), tighten the electrical cord using the
cable clamps provided and reinstall flange B) and the grille A), making sure that
the screws are correctly tightened.
Wiring diagrams
There are 4 different wiring methods , based on the choice to connect a
potentiometer (Vortice or different) or not to the product .
-
Img A. : Shows the two advised wiring diagrams to connect the vortice’s
potentiometers POT (12828) POT IT (12826) to the product .
-
Img B. : Shows the wiring diagrams used to connect any other 10 Kohm
potentiometer from the market.
-
Img C. : Shows the wiring diagram used when there’s no potentiometer
connected to the product
NOTE
: (with this wiring the product will always
run at its maximum speed).
