Vortice THERMOLOGIKA SOLEIL SYSTEM, Instruction Booklet

Page: 12 / 52

12
In compliance with the safety constraints listed in this document, TSS is compatible with both horizontal and
vertical position installation using the respective fastening devices (fig.2).
Use
Use the switch connected during installation to switch the TSS device on/off.
In the case that the device is connected to the Power Regulator (optional accessory code 21.434), on/off and
regulation of the delivered power are carried out by means of the respective commands on the Regulator.
Cleaning
Occasionally remove dust on the satellite dish and bulb with a clean brush or compressed air so as to always
guarantee the maximum caloric efficiency of the TSS device.
Electrical connections
If TSS is installed OUTSIDE, TSS can be directly connected to the electrical grid.
For INSIDE installations :
For the different connection modes see figure A.
To connect the appliance in conformity with the current regulations it is necessary to use one of the following
modes. (fig. A)
D1: wi-fi remote controller to predict at installation (cod. 21380).
D2: plug activable through wi-fi (cod. 21379).
D3: plug activable through wi-fi with temperature sensor (cod. 21378).
Optional accessories
- For series or parallel assembly of multiple lamps, it is possible to order an optional additional accessory code
21.460 for series connection and code 21.461 for parallel connection (fig. 19).
- To control the intensity of the lamp is possible to order the DIMMER SYSTEM (cod. 21434)
ENGLISH