8
Luftkappe
14 ORIGINAL SOLO AIR SEALHEAD ONLY
Install the wave washer over the thinner section of
the Solo Air sealhead, followed by the flat washer
as shown. Make sure the seal head assembly is
oriented correctly.
DEBONAIR B1 SEALHEAD ONLY
Install seal head onto shaft.
NOTE:
• We do NOT reinstall the topout bumper.
•
Make sure the seal head is close to or touching
the piston when installed. If it’s pushed a long way
into the stanchion before the sealhead is reinstalled,
you can trap too much air in the negative chamber,
which will result in your fork “sucking down” even
when pressurised as it is not able to extend far
enough to equalise pressures between positive and
negative chambers.
LUFTKAPPE INSTALLATION COMPLETE.
Remove two bottomless tokens from beneath the top cap if they are installed.
16
15
Thoroughly coat piston with generous amount of Slick Honey & install shaft back into fork as per
manufacturer instructions.
Continue servicing the fork as per Rockshox’s instructions if you are servicing the damper or
replacing the wiper seals, or skip to the reassembly instructions.
NOTE:
Ensure footbolts are done up with the fork fully extended. If they’re done up with it partly or
completely compressed, the fork will suck down into its travel.
