Ceramic Master Е1000 en v3
9
PARAMETERS AND PROGRAMMING
In order to change the value of a parameter it is
necessary to do the following steps:
Some of the parameters can be skipped. This can be done
by pressing button SKIP. In this way is skipped not only
the given parameter but also the whole phase. The
parameters that can be skipped are described later in the
text.
There are three possible ways of leaving the
programming mode after you have finished with the
changes in the parameters’ value:
FIRST EXIT:
SECOND EXIT:
THIRD EXIT:
The indicator of button RUN will flash in green in working
mode if the temperature defined by the parameter IDLE
TEMP is reached and if the temperature is not
reached it will flash in red.
With the multi functional rotary knob chose the
program which parameters you want to change;
Press button PROG. Indicator of the button RUN
begins to blink green/red and you can see on the
display:
Рхх : VIEW DATA
ENTRY TEMP xxxx
This is the first parameter. Turn left/right the MFRK
in order to chose the parameter you want to change;
Press button RUN in order to chose the value of the
parameter you want to change. If you have chosen
the first parameter you would see on the display:
Рхх : EDIT DATA
ENTRY TEMP xxxx
Indicator of the button RUN turns off and the red
indicator on the button STOP begins to blink.
Turn the MFRK to change the parameter value.
Press button STOP in order to leave the programming
of the current parameter. Indicator of the button RUN
begins to blink again in green/red which means that it
is possible to program next parameter.
press button ESC. This will CANCEL all the changes that
are made in the parameters’ value in the program.
press button ENTER. This will save the changes that are
made in the parameters’ value ONLY FOR THE TIME OF
EXECUTION OF THE PROGRAM. After the end of the
program all the changes are canceled.
press button PROG. This will SAVE all the changes that
are made in the parameters’ value permanent.