8
EN
WWW.VONROC.COM
preventer in the water pipe to prevent dirty
water flow back to the drinking water system.
The backflow preventer shall comply with EN
60335-2-79 ANNEX AA.
2. MACHINE INFORMATION
Intended use
The high pressure cleaner PW504AC is quick and
efficient for cleaning vehicles, machines, boats,
buildings, etc. Only clean vehicle engines in areas
in which suitable oil traps are installed.
TECHNICAL SPECIFICATIONS
Model No.
PW504AC
Voltage
220-240 V~ 50/60Hz
Input power
1400 W
Max. pressure water supply
12 bar
Max. water temperature
50 °C
Rated flow rate
5.5 l/min
Max. flow rate
6.5 l/min
Rated pressure
80 bar
Max. pressure
110 bar
Weight
6.7 kg
IP class
IPX5
Protective class
II
Lpa (sound pressure)
74.6dB(A) K=3dB(A)
Lwa (sound power)
88.3dB(A) K=3dB(A)
Max. LwA (sound power)
92dB(A)
Vibration
2.089m/s
2
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. High pressure cleaner
2. On/off switch
3. Water inlet filter
4. Hose holder
5. Water outlet
6. Gun holder
7. Handle
8. Cable holder
9. Spray gun
10. Adjustable spray lance
11. Turbo lance
12. Lance extension
13. Cleaning needle
14. High pressure hose
15. Patio cleaner extension
16. Patio cleaner
17. Detergent bottle
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembly of the handle and hose holder (Fig. A, B1)
1. Assemble handle (7) and hose holder (4) as
shown in Fig. B1.
2. Tighten the screws.
Assembly of the gun holder and cable holder
(Fig. A, B2)
Assemble gun holder (6) and cable holder (8) as
shown in Fig. B2.
4. OPERATION
The machine may cause electrical
disturbances when starting.
The motor of this pressure washer will NOT
run. It will only operate when the trigger is
squeezed.
The cleaner must only be used with clean
water; use of unfiltered water or corrosive
chemicals will damage the cleaner.
If the motor stops and fails to restart, wait
2-3 minutes before restarting. THERMAL
CUTOUT TRIPPED.
Turning on (Fig. A, C)
1. Turn the switch (2) to the “OFF/0” position.
2. Ensure that you have a suitable water supply to
feed the pressure washer.
3. Connect lance (10 / 11) and lance extension
(12) as shown in Fig. C1.
4. Connect the high pressure hose (14) to the
washer as shown in Fig. C2 and connect the
spray gun (9) to the high pressure hose (14) as
shown in Fig. C3.
