VONROC PH501AC, Original Instructions Manual

Page: 6 / 56

6
EN
WWW.VONROC.COM
matches the device.
• Check that the carabiners close properly and
that the device hangs immovably. It must not be
able to slide, drop, slide or the like! Only operate
the heater when it is in the upright position.
Assembling the remote control (Fig. B)
• Flip the remote control (8) to the backside and
remove the battery cover.
• Insert 2 AAA/ Alkaline type batteries into the
remote control (8) in accordance with the
instructions and polarity of the batteries..
• Change the batteries in the same way depicted
above.
4. OPERATION
Switching on/off (Fig. A, B)
The heater can be turned on and off using the re-
mote control (8) only. Before use, the power switch
(5) on the heater must first be turned on. Without
a remote control, the heater cannot be operated. If
you do not have the remote control in your posses-
sion, please contact Vonroc customer service.
• First turn the switch (5) on the heater to the
‘ON’ position.
• Press the button (9) on the remote control (8) to
turn the heater on.
• To turn the heater off, again press the button (9)
on the remote control (8).
• Press the switch (5) on the heater to the ‘OFF’
position to power off.
Note: Make sure to point the remote control (8) in
the direction of the remote control receiver (10). All
VONROC heaters and their remote controls use the
same frequency, so it is possible to control several
heaters with just one remote.
5. MAINTENANCE
Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
CAUTION: Risk of Electric Shock. DO NOT
open or try to repair the heater yourself.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Re-move very persistent dirt using a soft cloth moi-
stened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
• DO NOT use alcohol, gasoline, abrasive pow-
ders, furniture polish or rough brushes to clean
the heater. This may cause damage or deteri-
oration to the surface of the heater.
• DO NOT immerse the heater in water
• Wait until the heater is completely dry before
use.
ATTENTION:
• Always disconnect the heater from the electrici-
ty supply and allow it to cool before attempting
to clean it.
• If the heater has collected dust or dirt inside
the unit or around the heating element, have to
unit cleaned by a qualified service agent. Do not
operate the heater in this condition.
• The only maintenance required is cleaning of
the external surfaces of the heater.
• Do not touch the heating element with bare
fingers, as residue from your hand could affect
the life of the lamp. If it is accidentally touched,
remove the finger marks with a soft cloth moi-
stened with mentholated spirit or alcohol.
• Do not attempt to repair or adjust any electrical
or mechanical functions on this heater.
• The heater contains no user serviceable parts.
Should the product suffer damage or break-
down, it must be returned to the manufacturer
or its service agent.
• Damaged supply cords to be replaced by the
manufacturer, service agent or similarly quali-
fied person in order to avoid hazard.
Storage
Store the heater in a cool, dry location when not
in use to prevent dust and dirt build up. Use pack-
aging carton to store.
Trouble Shooting
If the heater will not operate, please check the
following before seeking repair or service:
• Check if the power cord is plugged into an
electrical outlet, if not plug in.