EN
9
WWW.VONROC.COM
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Removing and mounting accessories
Use only 3/8" (9.5mm) impact accessories.
Non-impact accessories may break and
cause a hazardous condition. Inspect
accessory prior to use to ensure that it
contains no cracks.
• Turn off the machine.
• Move the direction reversing switch (7) to the
middle position to lock the movement of the on/
off switch.
• Remove socket from chuck (6), if there is one.
• Click the new socket on the chuck (6).
• Check if the socket is properly attached.
• To remove the socket, simply pull it off.
4. OPERATION
Switching the machine on and off (Fig. A)
The on/off switch (5) is used for activating the
machine and adjusting rotation speed.
• Pressing the on/off switch (5) will activate the
machine, the further the switch is being pus-
hed, the faster the drill will turn.
• Releasing the on/off switch (5) will stop the
machine.
• Move the direction reversing switch (7) to the
middle position to lock the movement of the on/
off switch.
Only lay down the machine when it has
stopped running completely. Do not place it
on a dusty surface as particles of dust
could get into the mechanism.
Adjusting the direction of rotation (Fig. A)
• Set the direction switch (7) to position
in
order to drive screws or nuts.
• Set the direction switch (7) to position
in
order to remove screws or nuts.
Work light (Fig. A)
The machine is equipped with a work light (4) to
illuminate the work location.
• It automatically switches on when the on/off
switch is being pressed.
• It automatically switches off when the on/off
switch is released again.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
