VONROC 8717479095360, Original Instructions Manual, Page: 15 / 162

EN
15
WWW.VONROC.COM
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the CD802AA charger
(Fig. K)
1. Take the battery (23) from the machine.
2. Turn the battery (23) to upside down position and
slide it onto the charger (26) as shown in Fig. K.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(27) will lighten up and show the charger status.
The charger has 2 LED indicators (27) which indicate
the status of the charging process:
Red LED
Status Green LED
status
Charger status
Off Off No power
Off On
Standby mode:
- No battery is inserted or,
- Battery inserted but
charging has finished
On Off Battery charging in progress
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
Charging the battery with the CD820AA dual
charger (Fig. L)
1. Take the battery (26) from the machine.
2. Turn the battery (26) to upside down position
and slide it onto the charger (30) as shown in
Fig. L.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (31, 32, 33) will lighten up and show
the charger status.
The charger has 6 LED indicators (31, 32, 33)
which indicate the status of the charging process:
Item Conditions LED colour
Red Amber Green
Stand by Power on On On On
Charging Started charging
(10-19V DC±0.5V DC)
Blink Off Off
Halfway charging
(19-20V DC±0.5V DC)
On Blink Off
Finished charging
(20-21V DC±0.5V DC)
On On Blink
Fully
charged Trickle charging
≤300±150mA
On On On
Stop charging
High tem-
perature High-temperature
protection of the
battery works
On On On
• Fully charging the 4Ah battery may take up to
85 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from the
charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
Assembling the lower handle (Fig. A, B)
1. Mount the lower handle (14) onto the lawn
mower body, as shown on figure B.
2. Put the washer (34C) onto the bolt (34B).
3. Screw the handle adjustment knob (34A) onto
the bolt (34B) with assembled washer and
secure the handle by closing it.
4. Repeat these steps for the other side.
Assembling the upper handle (Fig. A, C, D)
1. Attach the upper handle (1) to the lower handle
(14).
2. Secure the upper handle (1) by inserting the
bolts (15B), washers (15C) and handle knobs
(15A) as shown on figure C.
3. Fixate the cable to the handle by using the
cable holders (6), as shown on figure D.