CLEANING & MAINTENANCE
Clean dust and debris from the staple gun vents and
magazine compartment using compressed air.
Do not use solvents, or household cleaning
detergents containing ammonia to clean the 9A
Electric Tacker.
Use only mild soap and a damp cloth to clean the 9A
Electric Tacker.
Always unplug
the 9A Electric Tacker from the mains supply before performing any cleaning & maintenance tasks
CAUTION
Do not alter, attach special fixtures
to, or redesign parts of the 9A Tacker. Do not
fire without staples, as this may cause damage
to the 9A Tacker.
NOTE
Do not lubricate. The 9A Tacker does
not require oil or grease to operate.
TROUBLESHOOTING
PROBLEM
SOLUTION
Ensure the 9A Tacker is plugged in and switched on
at the mains supply.
Ensure the 9A Tacker is plugged in and switched on
at the mains supply.
Check capacity of staples and refill appropriately if
needed, following the instructions in the
‘Inserting
Staple Magazine’
section.
Check capacity of staples and refill appropriately if
needed, following the instructions in the
‘Inserting
Nail Magazine’
section.
Ensure you are applying the two stage safety to
activate the Gun (see page 6)
Ensure the 9A Tacker is plugged in and switched on
at the mains supply.
Check for jams (see the
‘Clearing a Jam’
section
above for guidance on clearing the blockage).
NO POWER
TOOL WILL NOT START
GUN NOT FIRING
Summary of Contents for 3515389
Page 1: ...9AMP ELECTRIC TACKER 3515389 Instruction Manual...
Page 15: ...USER NOTES...
