VonHaus 3500181, Manual

Page: 7 / 24

A5P | 01
SECURING THE SANDER
WORKBENCH: If the Belt and Disc Sander is to be used
in a permanent location, it should be fastened securely
to a firm supporting surface such as a workbench.
NOTE: Moutning Bolts not supplied.
• Place the Bench and Disc Sander in the location you
require and mark the 3 holes on the base.
• Drill the holes using a 3/8” Drill Bit.
• Place the Bench and Disc Sander back into the
choosen location and align up holes.
• Using the Hex Bolts (Not Supplied) secure the Belt and
Disc Sander.
NOTE:
Bolt length should be 1.1/2” plus the
thickness of the bench top.
CLAMPING: If your Belt and Disc Sander is to be
used as a portable tool, it is recommended you fasten
it permanently to a mounting board that can easily be
clamped to a workbench or other stable surface.
The mounting board should be of sufficient size to
avoid tipping while Belt and Disc Sander is in use. Any
good grade plywood or chipboard with a 3/4 in. (19
mm) thickness is recommended.
CONTENT LIST
1. Sanding Belt
2. Belt Tension Release
3. Sanding Belt Tensioning Screw
4. Grinding/Sanding Disk
5. Bevel Scale
6. Vacuum Outlet
7. On/Off Switch
8. Sanding Belt Angle Adjustment Screw
9. Power Cable
10. Mounting Screws x 3
11. Edge Stop
12. Sanding Table
13. Mitre Guide
14. Sanding Disc Face Plate
15. Locking Screw
16. 6mm Hex Key
17. Face Plate Screws with Anti Vibration Washer x 2
18. Hex Bolts with Washers x 2
19. Face Plate