BASE ASSEMBLY
Place the body of the Radiator upside down on a
scratch-free surface, making sure that it is stable and
will not fall.
Locate the U-Shaped Bars and remove the Wing
Nuts.
Locate the Bars at the front and rear of the Radiant
Fins.
Attach the Wheel Mounting Bracket onto the
U-Shaped Bar and secure into place using the
previously removed Wing Nuts.
Remove the End Cap Screw from the Wheel, thread
the Wheel onto the Wheel Mounting Bracket and
secure into place with the End Cap Screw.
Ensure everyting is tightend and secure before
turning upright.
IMPORTANT: After assembly, stand the Radiator
upright for 1 hour before switching on. This will allow
the oil to settle into the correct position.
If the item is missing these parts, please contact
customer services.
Spare base assembly parts
3000145: Black
3000144: White
SAFETY FEATURES
This Radiator is fitted with an
overheat protection
switch
(thermal cut-out) which will power off the
appliance automatically in case of overheating.
Should this occur, unplug the appliance and allow to
cool fully for approximately 30 minutes.
Follow the operation instructions to restart
the appliance after removing the source of the
overheating (poor ventilation, item covering the
Radiator etc.). The Radiator should function normally.
Should the problem persist, please contact DOMU
Brands Customer Services.
To avoid damage and to regulate the temperature,
this Radiator is fitted with a
thermostatic safety
device.
The safety device will activate and cut out
the power to the Radiator once a certain temperature
is reached. The Radiator will start again once the
temperature has lowered.
The Radiator is also fitted with a
tip switch
which
will cut off the power to the Radiator if it is knocked
over. Should this happen, disconnect at the mains
and allow to cool fully before attempting to move the
Radiator. Inspect the Radiator for damage. If - and
only if - the Radiator is free from damage, plug back
into the mains. The Radiator should function normally.
