Von Duprin CDXP98, Installation Instructions Manual

Page: 5 / 12

5
6
If Necessary, Remove NL Drive Screw
5
Prepare lock side of door
for device and trim.
See “
Preparation Chart
” on page 3 for
drill, tap, and cut-out information
X
X
See trim instructions for pull side door
preparation. Line X - X in trim instruc-
tions is same as vertical device C .
L
7
Secure device center case to
door and install trim (if using).
Center
case
cover
cente
r
case
Trim
(optional)
1-1/2” Minimum clearance
(with end cap removed)
if device is too long for
door, see “ Cut Device ”
on back cover
F
G
8
Install mounting bracket
and end cap.
Secure
mounting
bracket
and end cap
Mounting
bracket flush
Lev
el d
evic
e
Mark and prepare 2
mounting holes
See “ Preparation Chart ” on page 3 for drill and tap sizes
D
E
C
IMPORTANT: Two support
screws MUST be installed
With NL drive screw removed, key locks and unlocks lever, knob,
or thumb piece. For trims listed below, REMOVE NL drive screw.
996L 696TP 990TP
996K 697TP
With NL drive screw installed, key retracts latch bolt. DO NOT remove
NL drive screw for the following applications:
NL, EO, DT trims and 98/99-2 double cylinder devices (i.e. TP-2,
L-2, and K-2).
If trim being installed is "BE" (i.e. 996L-BE), trim lock tumbler on
back of device must be in UP position before device is installed.
This allows trim to be unlocked at all times.
*
*996L-BE
*996K-BE *E996L
*E996L-BE *696TP-BE
*697TP-BE *990TP-BE
NL drive screw
Factory installed on
back of center case
Correct
Orientation
(RHR shown) Incorrect
Orientation
trim lock
tumbler in
UP position If necessary,
remove drive
screw and
rotate cam
until trim lock
tumbler is in
UP position,
then reinstall
drive screw
360˚