12
1. Remove mortise cylinder cam and reinstall in reverse (Figure 1).
2. Insert key and rotate cam to install the cylinder to the cover plate (Figure 2).
3. Remove key to slide cover plate in position in the mechanism case.
Std. mortise
cylinder
Mortise
cylinder cam
Std. mortise
cylinder
Mortise
cylinder cam
CD function conversion
Dogging procedure
Turn cylinder key approximately
¹⁄₈
turn for standard dogging
Depress pushbar
Figure 1
Figure 2
Std. mortise
cylinder
Offset toward
pushbar
Dogging plate
cover
Cylinder collar
Cylinder
locking washer
Cylinder
locking nut
Mechanism
case
OPTIONAL EQUIPMENT
CD (CYLINDER DOGGING)
37
Adjust Top Strike as Necessary, then Install the
Third Strike Screw to Fix the Strike Position.
38
Install Center Case Cover and Door Cover Plate.
Remove protective film
from pushbar
Metal
Wood
#25 x
¹⁄₂
" Deep
#10-24
¹⁄₈
" Drill
Pilot 1" Deep
OR
(metal)
(wood)
36
Perform Functional Test of Door.
For 2-Point Latch Only
a. Depress pushbar. Door should begin to open when pushbar is nearly
fully depressed. If necessary, refer to Step 35 to readjust lift finger.
b. With door closed, top latch should be secure.
c. With door closed, bottom latch should be secure.
d. Confirm that bottom latch does not drag against floor when door is
opened. If this occurs, remove latch adjustment pin and raise latch,
then reinsert pin in next notch.
Pin must go thru
both sides of bracket
Squeeze tabs on cap
before reinserting pin
To remove pin, slide a
screwdriver beneath the
latch adjustment pin cap