2
Instructions
1. Determine the horizontal centerline of the exit device latch and transfer centerline to the frame stop.
2. Position the template onto the frame aligning with centerline and against the closed door.
Center-punch the two mounting holes and the wire access hole as shown.
3. Drill and tap the two mounting holes and drill the wire access hole.
4. Test fit electric strike to ensure full latch engagement. Add provided spacer if required.
5. Make wire connections from the power source to the appropriate wire harness supplied.
Use the 12V harness for 12VDC. Use the 24V harness only for 24VDC.
6. Mount the electric strike with 1/4-20 UNC screws provided in the horizontal mounting holes
(the outer slots). Adjust electric strike horizontally until exit device latch fully engages with the door
closed.
(Note: Ensure a 1/16” [1.5mm] clearance between exit device latch and the electric strike is
maintained.)
7. Tighten the two mounting screws and check operation. Adjust the horizontal position of electric strike
as required.
8. Using the electric strike as a template, drill & tap for 1/4-20 UNC screws the two locking holes. Using
the 1/4-20 UNC screws provided secure the electric strike through the locking holes.
NOTE:
Wire access hole location is relative to the exit device orientation.
LOCKING SCREW
(2 PLACES)
3/4" (19.0 mm)
WIRE ACCESS HOLE
1/4-20 UNC
(2 PLACES)
DOOR FRAME
DOOR FRAME STOP
MOUNTING SCREW
(2 PLACES)
MOUNTING SCREW
(2 PLACES)
1/4-20 UNC
(2 PLACES)
3/4" (19.0 mm)
WIRE ACCESS HOLE
DOOR FRAME STOP
NOTE: Not to scale. Specifications are subject to change without notice.
