Volvo XC90 Hybrid 2016, Owner'S Manual

Page: 280 / 546

||
DRIVER SUPPORT
* Option/accessory, for more information, see Introduction. 278
Standby mode due to driver action
If a turn signal is used or if the accelerator pedal
is pressed, Pilot Assist will temporarily go into
standby mode. When the turn signal is switched
off or the accelerator pedal is released, Pilot
Assist will reactivate automatically.
Automatic reactivation from standby mode can be
done within 1 minute. After 1 minute has
elapsed, Pilot Assist must be reactivated man-
ually by pressing the
button.
Pilot Assist will temporarily go into standby mode
if:
•
the brakes are applied
•
the gear selector is moved to the
N
position.
The driver will then have to regulate speed and
distance to the vehicle ahead, or reactivate Pilot
Assist manually by pressing the
button on
the left-side steering wheel keypad.
Automatic standby mode
Pilot Assist interacts with other systems, such as
Electronic Stability Control. If any of these other
systems are not functioning properly, Pilot Assist
will automatically be deactivated.
WARNING
If this happens, the driver will be alerted by an
audible signal and a message in the instru-
ment panel. The driver will have to adapt the
vehicle's speed, apply the brakes when nec-
essary and keep a safe distance to the vehicle
ahead.
Pilot Assist switches automatically to standby
mode if:
•
the camera cannot detect the traffic lane's
side marker lines
•
the vehicle ahead is not within a reasonable
(detectable) distance
•
the driver's hands are not on the steering
wheel
•
the driver unbuckles the seat belt
•
engine speed (rpm) is too high/low
•
the wheels lose traction
•
brake temperature is too high
•
The camera lens/radar sensor is covered by
e.g., wet snow or if heavy rain interferes with
radar waves
Reactivating Pilot Assist from standby
mode
–
Press the button (1).
> The most recently set speed will be used.
Related information
•
Pilot Assist
*
(p. 273)
Setting a Pilot Assist time interval
Different time intervals to the vehicle ahead can
be selected and are shown in the instrument
panel as 1–5 horizontal bars.
Changing the time interval
The greater the number of bars,
the longer the time interval.
One bar between the vehicles
represents a time interval of
approximately 1 second; 5 bars
is approximately 3 seconds.
The same symbol appears if Distance Alert is
activated.