03 Instruments and controls
03
}}
85
Stalk switch and knob for headlamp control in
AUTO
position.
The function can start while driving in the
dark when the car's speed is 20 km/h or
higher.
Activate/deactivate AHB by moving the left-
hand stalk switch towards the steering wheel
to the end position and then releasing. Deac-
tivation when main beam is on means that the
lights are reset directly to dipped beam.
Car with analogue combined instrument
panel
When AHB is activated the
symbol illu-
minates in the instrument's information dis-
play.
When main beam is switched on the
symbol also illuminates in the combined
instrument panel. This also applies for Xenon
headlamps if the main beam is partially
dimmed, i.e. as soon as the light beam shines
with slightly more than dipped beam.
Car with digital combined instrument panel
When AHB is activated the
symbol
turns white in the instrument's information
display.
When main beam is activated, the symbol
shines blue. This also applies for Xenon head-
lamps if the main beam is partially dimmed,
i.e. as soon as the light beam shines with
slightly more than dipped beam.
Manual operation
NOTE
Keep the windscreen surface in front of the
camera sensor free from ice, snow, mist
and dirt.
Do not stick or attach anything to the
windscreen in front of the camera sensor
as this may reduce effectiveness or cause
one or more of the systems dependent on
the camera to stop working.
If the message
Active main beam
Temporary unavailable Switch manually
is
shown in the combined instrument panel's
information display then you have to switch
manually between main and dipped beam.
However, the knob for headlamp control can
still remain in position
. The same
applies if the message
Windscreen sensors
blocked See manual
and the
symbol
are shown. The
symbol goes out when
these messages are shown.
AHB may be temporarily unavailable e.g. in
situations with dense fog or heavy rain. When
AHB becomes available again, or the wind-
screen sensors are no longer blocked, the
message extinguishes and the
symbol
illuminates.
WARNING
AHB is an aid for using optimum light
composition when conditions are favoura-
ble.
The driver always bears responsibility for
manually switching between main and
dipped beam when traffic situations or
weather conditions so require.
Summary of Contents for XC 60
