Volvo S80 -, Owner'S Manual

Page: 305 / 422

08 Starting and driving
08
303
Towing eye
The towing eye is screwed into a threaded
socket behind a cover on the right-hand side
of the bumper, front or rear.
Attaching the towing eye
Take out the towing eye that is located
under the floor hatch in the cargo area.
The cover for the towing eye's attach-
ment point is available in two variants
which must be opened in different ways:
•
Open the variant with a recess using a
coin or similar inserted in the recess,
turning it outwards. Then turn out the
cover completely and remove it.
•
The second variant has a marking
along one side or in a corner: Press the
marking with a finger and fold out the
opposite side/corner at the same time
using a coin or similar - the cover turns
around its axis and can then be
removed.
Screw the towing eye right in up to its
flange. Turn in the towing eye firmly e.g.
using the wheel wrench.
After use, unscrew the towing eye and
return it to its place.
Finish by refitting the cover onto the
bumper.
The towing eye may be used to pull the car
up onto a recovery vehicle with a flatbed plat-
form. The car's position and ground clear-
ance determine whether it is possible. If the
slope of the recovery vehicle's ramp is too
steep, or if the ground clearance under the
car is inadequate, then the car may be dam-
aged if you try to pull it up using the towing
eye. Raise the car using the recovery vehi-
cle's lifting device if necessary.
WARNING
No one/nothing is allowed to remain
behind the recovery vehicle while the car
pulled up onto the flatbed platform.
IMPORTANT
The towing eye is only designed for towing
on roads -
not
for pulling the car unstuck
or out of a ditch. Call a recovery service for
recovery assistance.
Related information
•
Towing (p. 301)
•
Recovery (p. 304)