Volvo S60 inscription, Owner'S Manual Supplement

Page: 113 / 170

PRACTICAL INFORMATION
}}
* Option/accessory. 111
WARNING
•
The engine should not be running when
changing bulbs.
•
If the engine has been running just prior
to replacing bulbs in the headlight hous-
ing, please keep in mind that components
in the engine compartment will be hot.
WARNING
•
Active Bending Lights
*
– due to the high
voltage used by these headlights, these
bulbs should only be replaced by a
trained and qualified Volvo service techni-
cian.
•
Turn off the lights and remove the remote
key from the ignition before changing any
bulbs.
Related information
•
Bulbs – headlight housing (p. 111)
•
Bulbs – taillight housing (p. 116)
•
Bulbs – vanity mirror lighting (p. 117)
•
Bulbs – license plate lighting (p. 116)
Bulbs – headlight housing
The entire headlight housing must be lifted out
when replacing all front bulbs.
Removing the headlight housing
Pull out the headlight housing's locking pins.
Remove the headlight housing by alterna-
tively pulling the front and rear edges until it
can be lifted out.
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
Unplug the wiring connector by holding down
the clip with your thumb.
Pull the connector out with the other hand.
5. Lift out the headlight housing and place it on
a soft surface to avoid scratching the lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into place.