P 120
8-1 4
Fig. 31.
Upper attaching screw for ventilation
window
3.
Unscrew the screws which hold the guide rail
for the winding window, see Fig. 32. This only
applies to the extended guide rail on the front
doors.
4.
Remove the upper guide strip with a screw-
driver as shown in Fig. 33.
5.
Lift up the window as shown in Fig. 34.
Fig. 33.
Removing upper guide strip
VOLVO
101 039
VOLVO
23250
Fig. 32.
Attaching screw for winding window
guide rail
VOLVO
23246
Fig. 34.
Lifting out the ventilation window
Window winder with mechanism
REMOVING AND FITTING
Carry out operations 1-5 under "Removing the
door upholstery".
Carry out operations 1-5 under "Ventilation win-
dows, removing and fitting".
1.
Remove the clip which holds the carrier on the
winding cable to the rail under the window
and lift it up as shown in Fig. 35. On the rear
doors there is no carrier and the clip fits
directly on the winding chain.
2.
Release the cable tensioning device by
slackening the nut for the catch screw on the
lower pulley. Lift off the cable and chain.
3.
If necessary remove the upper pulley, lower
pulley with tensioning device and winding
sprocket itself. The winding sprocket is remov-
ed by unscrewing the four screws, Fig. 36,
after which the sprocket with shaft is lifted out.
Before fitting the winding window, make sure
that the guide strips and seals are in good
condition. Worn or
,
damaged parts must be
replaced.
The cable for the winding mechanism should
be tensioned well but not too hard. Lubricate
the cable and chain with grease and the pulley
and winding sprocket with oil.
After fitting, check that the window runs easily
i n the guide rails.
