Figure 8
14. Tighten down the adapter with the unit injector's attaching yoke. Tightening torque: 40 Nm (30 lbf ft).
Figure 9
V1022271
15. Install the rocker arm bridge with the lifting tool 9990185. Tighten the bolts along the whole rocker arm shaft to
prevent warping and to make sure that the guide pins fit in the camshaft's support bearing. See
.
214 Rocker arm shaft, tightening torques
16. Install the IEGR control valve. Check that the seal ring is placed correctly before the bolts for the IEGR control valve
are tightened.
17. Transfer the rubber bands so that they are located between the adapter and the unit injector's rocker arm. This is
done so that the rocker arm will not rattle.
