32
IMG-242239
Screw the right-hand screw fully in the camera.
Align the template so that the right-hand hole in the template is
directly above the right-hand hole in the lid.
Hold the template in position (inside the hole in the lid) and, at
the same time, tighten the camera's right-hand screw so it holds.
Align the left-hand holes with each other, fit the screw and
tighten the camera.
Cargo compartment, preparations
33
IMG-242240
Cargo compartment, preparations
Applies to cars with two rows of seats
Fold up the floor hatch (1). If the floor hatch is equipped with a
grocery bag holder, the holder is secured with a strap on both
ends of the storage compartment. Detach the straps.
Remove the storage compartment under the floor hatch.
Remove the floor hatch by folding it almost completely closed
and pulling it backwards from the mountings until it releases.
Applies to cars with three rows of seats and integrated
carrier bag holder on the underside of the floor hatch
Fold up the floor hatch (1).
Detach the two straps on the panel under this. Lift up the rear
edge of the panel, fold the floor hatch back towards the panel
and lift out the floor hatch with the panel.
Applies to cars with three rows of seats without an
integrated carrier bag holder
Fold up the floor hatch (1) at the rear edge and lift it out.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Parking assistance, camera, XC90- 31270162 - V1.2
Page 19 / 64