25
IMG-330258
Take the jointing cable and press it firmly into the engine block
heater's connector. Then press a locking sleeve from the kit over
the joint.
26A
IMG-330259
26B
IMG-330263
Illustrations A and B
Pull the radiation shield down so that it fully covers the connector
on the heater.
Take the grey tie strap from the kit and tighten the radiation shield
at the bottom to the heater.
Route the cable from the engine block heater to the left toward
the thick cable harness at the starter motor and up where the
gearbox is connected to the engine. Route the cable to the front
side of the engine/gearbox.
Secure the wiring at the existing thick cable harness. Use the tie
strap from the kit.
Note!
Do not clamp the cables so that they make contact with pipes or
hoses for the ACC, brakes or power steering.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Electric engine heater, 230 V- 31269607 - V1.2
Page 17 / 25