49
M3702551
Take the foam tape from the kit. Install the tape on the section of
the long single cable to be routed under the sill trim panel for the
tailgate. This is to prevent rattling.
Take the long single cable that was routed with the cable
harness from the radio. Route the cable under the carpet to the
left-hand side of the car.
Clamp the single cable at the existing cable harness on the left-
hand side of the cross member. Use a tie strap (1).
Route the cable inside the carpet and under the cable ducts (2)
and (3) along the left-hand side of the car towards the cargo
compartment. Ensure that the cable is securely pressed down
between the sills and carpets.
Route the cable under the existing wiring and the connectors by
the cable duct (3).
50A
M3702553
50B
M3702818
Illustration A
Route the cable along the left rear wheel arch to the rear end of
the left floor support.
Remove the outer screws (1) in the tailgate sill trim panel.
Pull up the tailgate sill trim panel on the left-hand side. Insert the
cable between the floor support and the sill trim panel.
Slide the cable as far in towards the rear cross member as
possible. Ensure that the cable is not trapped.
Route the cable along the existing cable harness by the rear
cross member and over to the right-hand side of the car. Insert
the cable between the sill trim panel and the floor support in the
same way as on the left-hand side.
Illustration B
Clamp the cable using tie straps (2).
Press the sill trim panel back into place. Reinstall the two
screws.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Hands free unit for carphone- 30730011 - V1.1
Page 32 / 45