2003 VOLVO XC90
●
Lift the wheel and place it on the hub.
●
Install the wheel bolts and tighten handtight. Using the lug wrench, tighten crosswise until all bolts
are snug.
●
Lower the vehicle to the ground and alternately tighten the bolts crosswise to 102 ft. lbs. (140 Nm).
●
Install the wheel cap (where applicable).
WARNING!
- The jack must correctly engage the bar in the jack attachment. The vehicle's weight must not rest on
the jack attachment. See illustration "Attaching the jack" above. Be sure the jack is on a firm, level,
non-slippery surface.
- Never allow any part of your body to be extended under a vehicle supported by a jack.
- Use the jack intended for the vehicle when replacing a wheel. For any other job, use stands to
support the side of the vehicle being worked on.
- Apply the parking brake and put the gear selector in the (P)ark position (or reverse on manual
transmissions).
- Block the wheels standing on the ground, use rigid wooden blocks or large stones. The jack should
be kept well-greased.
pg. 122 Wheels and tires
This page intentionally left blank
|
file:///K|/ownersdocs/2003/2003_XC90/03xc90_08.htm (12 of 12)12/30/2006 4:19:01 PM
