D3903662
30
D3903667
Install the bracket with the CD changer behind the wheel arch.
Use four screws (1) from the kit. See the illustration. Tighten the
screws
Applies to cars with rear acceleration sensors:
Remove the acceleration sensor behind the left-hand wheel arch
Install the CD changer as above. At the same time, reinstall the
acceleration sensor in the same rivet nut as before. The sensor
must be above the bracket for the CD changer. Use the same
screw as before. Tighten to 24 Nm (18 lbf.ft.).
Note!
The acceleration sensor must be securely installed with the
connector turned upwards. If the sensor is not secure,
movement may result in false values. This could result in poor
system performance when cornering for example.
31
D3903699
Connect cable (1) to the power supply
Connect the cable (2) to the radio
Secure the cable harness at the cable duct. Use a tie strap (3)
as illustrated
Clamp any cable excess to the cable harness.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
CD changer 10 CD- 30730089 - V1.0
Page 15 / 17
