Volvo Penta TAD940GE, Workshop Manual

Page: 7 / 42

5
Group 20
General information
Certified engines
The manufacturer certifies that both new engines and
those in use, which are certified for national or region-
al legislation, comply with the environmental require-
ments. Each product must correspond with the unit
used for certification. The following requirements for
service and spare parts must be complied with, for
Volvo Penta as a manufacturer to be responsible for
ensuring that engines in use comply with the stipulat-
ed environmental requirements:
Maintenance and service intervals recommended
by Volvo Penta must be complied with.
Only Volvo Penta Original Spare Parts intended
for the certified engine version may be used
Service related to injection pumps and injectors
must always be done by an authorized Volvo Pen-
ta workshop.
The engine must not be converted or modified in
any way, except for the accessories and service
kits which Volvo Penta has approved for the en-
gine.
Installation changes to the exhaust pipe and the
engine bay air inlet ducts (ventilation ducts) must
not be done without further discussion, since this
could affect exhaust emissions.
No seals may be broken by unauthorized person-
nel.
The general advice in the instruction book about oper-
ation, care and maintenance applies.
IMPORTANT! When spare parts are needed,
use only Volvo Penta Original Spares.
Use of non-original spareparts means that AB
Volvo Penta can no longer be responsible for
guaranteeing that the engine complies with the
certified version.
Any damage, injury and/or costs which arise due
to the use of non-original Volvo Penta spares for
the product in question will not be compensated
by Volvo Penta.
About the workshop manual
This workshop manual contains technical data for the
TAD940GE, TAD941GE, TAD940VE, TAD941VE,
TAD942VE, TAD943VE, TAD950VE, TAD951VE and
TAD952VE engines.
The Workshop Manual, Technical Data, contains all
the references from the workshop manuals to repair
instructions for the TAD940GE, TAD941GE,
TAD940VE, TAD941VE, TAD942VE, TAD943VE,
TAD950VE, TAD951VE and TAD952VE series.
The Workshop Manual is produced primarily for the
use of Volvo Penta workshops and service techni-
cians. For this reason the manual presupposes a cer-
tain basic knowledge and that the user can carry out
the mechanical/electrical work described to a general
standard of engineering competence.
Volvo Penta constantly improves its products, so we
reserve the right to make modifications without prior
notification. All information in this manual is based on
product data which was available up to the date on
which the manual was printed. Any material changes
introduced into the product or service methods after
this date are notified by means of Service Bulletins.
Spare parts
Spare parts for electrical and fuel systems are subject
to various national safety requirements. Volvo Penta
Original Spares comply with these requirements. No
damage whatever, occasioned by use of non-original
Volvo Penta spares for the product, will be compen-
sated by the warranty offered by Volvo Penta.