55
Maintenance: S drive and reverse gear
Oil change. MS25
Remove the dipstick. Suck up oil using an oil pump
through the hole for the dipstick. Measure out the
correct amount of oil and fill up through the hole for
the oil dipstick. For oil quality and capacity: See the
chapter ”Technical Data”.
IMPORTANT! Never overfill reverse gear. The
oil level should always lie at the recommended
level.
Oil change and filter cleaning. HS25
. Clean around the lid, so that there is no risk that
dirt could fall down into the filter housing.
. Undo screw () with a 6 mm Allen key. Remove
lid (). Replace and oil in the new O-rings in the
lid.
3. Lift up the filter (3).
4. Suck up the oil with an oil drain pump, via the oil
filter housing. Connect hose to the suction pipe
(4) at the bottom of the housing.
5. Measure up the correct quantity of oil and fill the
reverse gear with the oil via the oil filter housing.
Please refer to the “Technical Data” chapter for oil
grades and volume.
IMPORTANT! Never over-fill the reverse gear.
6. Install the new filter (3) in the filter housing.
7. Install the lid. Tightening torque 5-8 Nm.
8. Put the control lever in neutral. Start and run the
engine at 500 rpm for a few minutes to ensure
that the reverse gear oil cooler is filled with oil.
9. Stop the engine and check the oil level. Top up as neces-
sary.
1
2
3
4