Turn the controller on by pressing the power button on the display for 1 second.
There are two riding modes:
1.
PAS (pedal assist) and pedal only.
2.
If you are using PAS mode, the motor will only operate while the pedals are
turning, and the motor will start after several turns of the pedals. When
using PAS level 0 the motor will not start and you can ride the bicycle as a
normal push bike.
While riding and using the motor, the battery indicator will change as power is
consumed. When the indicator shows that the battery is out of charge, use the
pedals instead. The battery can be used again once it has been re-charged.
Note: The battery level is best judged by the display status of the
indicator during the steady running at full speed.
The riding distance after each battery charge will vary according to factors like
road type, hills, user weight, and wind direction. When starting the e-bike uphill,
tackling repeated steep hills or riding upwind, it is better to assist the motor by
pedalling in order to save power, and extend the lifetime of the motor and
battery.
After use, turn off the power switch.
Human powered riding
Keep the PAS level on 0 (default when powered on). No motor support will be
engaged.
USING YOUR BATTERY CHARGER
Before using the charger, please read the manual, including the warning label on
the charger and battery pack.
Do not expose the charger to rainy, snowy or wet weather, or to low
temperatures (below 0
℃
) or high temperatures (above 35
℃
). These conditions
may destroy the inner parts of the charger and battery pack.
