© Voltex Electrical 2016. All Rights Reserved.
®
Model
Dimension A (mm) Dimension B (mm)
Dimension C (mm)
VDEF-250
236
236
150
Fascia
242
242
-
Cut Dimension
210
210
-
VDEF-300
285
285
180
Fascia
308
308
-
Cut dimension
250
250
-
12.
Carefully cut around the line. Several holes drilled at a point inside the
marking will provide a convenient starting point for cutting the panel out.
13.
Remove the facia of the exhaust fan by pushing the spring on each side
together and then guide it through the slot.
14.
There are four mounting clips. Loosen the screw on each mounting clip and
slide all four clips toward the body of the exhaust fan (centre).
15.
The exhaust fan is supplied with a supply cord and plug.
16.
Check power to the socket outlet is isolated from the mains power supply
and plug the fan into the socket outlet.
17.
Insert fan into hole.
18.
Push the four mounting clips outwards. When the clips are fully extended,
tighten the screw on each mounting clip to lock the clip and exhaust fan in
place.
19.
Replace the fascia by pushing the spring on each side together and guiding
it back through the slot.
20.
Attach the free end of the ducting to the outlet of the appliance.
21.
WARNING:
The appliance shall, under no circumstances, be covered with
insulating material or similar material.
22.
Reconnect power to the socket outlet.
23.
Switch on appliance and check correct function and switch operation.
24.
Your installation is now complete.
