L
L
R
R
L
R
R
TIGHT
L
R
R
TIGHT
L
L
R
R
L
R
R
TIGHT
L
R
R
TIGHT
© Voltex Electrical 2015. All Rights Reserved.
®
1. Select threaded brace rods of an appropriate length, then screw the L and R brace rods
into the center (hexagonal) turnbuckle. Turn the turnbuckle in the direction indicating ‘tight’
by the arrow.
(*Select the Correct Hole Enlarging Brace Rods as blow “ PICTURE 1 “ )
2. Turn the threaded brace rods until the full unit is approximately the same size as the hole.
(
Attention:
make sure to keep the lengths of the rods on both sides as even as
possible)
* Select the Correct Hole Enlarging Brace Rods :
Hole Sizes
Brace Rods
52 ~ 72mm L 52-72 / R 52-72
72 ~ 92mm L 72-92 / R 72-92
Picture 1
V-230LT
Inst
ruction Manual
L
ocating tool for V-230
Hole Cutter
