background image

© Voltex Electrical 2019. All Rights Reserved.

®

WARNING:
This is a solid-state electronic device.
A low reading will be obtained during Insulation Resistance test (Megger test).
Please indicate at the switchboard which circuit this accessory has been 
installed on.

The USB outlet is designed for charging batteries in rechargeable USB devices only. 
Any other application can damage the USB supply unit or the attached equipment.
The dual USB outlet must not be connected to a total load greater than the rated 
load of 2 x 2.1A.

Never insert anything except a USB cable plug in the USB outlet. In the event of a 
short-circuit condition, the fuse inside the USB supply unit will blow and the supply 
unit will be rendered inoperative.

The USB outlet is not meant to provide power to operate electronic devices. Do not 
plug USB flash drives or disk drives into the USB Outlet.

Electrical installations periodically receive transient over voltages. The USB 
outlet has been designed to minimise the effect of such voltages on connected 
equipment. It may not give full protection for extreme over voltage transients such 
as those resulting from a close lighting strike.

Regular cleaning of the accessory is recommended. To clean the accessory:
1. WARNING: Ensure the accessory is switched off from the mains power supply  
     first.
2.  The decorative cover can be simply removed and wiped over using a damp cloth.
3.  The faceplate and aperture panel may be cleaned with a dry cloth.
    
CAUTION: To prevent damage to the accessory do not use alkaline cleaning agents 
or solvents when cleaning, use a soft cloth and a mild detergent.

USE

CARE INSTRUCTIONS

Reviews: