Page 3
Page 4
The 2.4GHz video signals pass easily through your homes interior walls, but the
signal maybe reflected by power wires or plumbing inside the wall. Usually a slight
adjustment of Receiver and / or Camera / Transmitter antenna will improve
reception. Take care not to force the antennas past their lock positions.
The most common source of interference are microwave ovens. Try to avoid mount-
ing the Receiver near a microwave oven or other source of RF interference such as
cordless phones.
USING THE CRS200 VIDEO SYSTEM
Motion detecting cameras
Each camera has a PIR motion sensor. When a camera detects motion an alarm
beeper will sound on the receiver and the receiver will output a signal to trigger a
CT220 VCR controller if installed. The volume control for the bleeper and the VCA
output (CT220 VCR Controller connection socket) is on the rear of the receiver.
Additionally a red light will flash on the camera.
Channels 1&2
Selected
Camera 1
Camera 2
Receiver
Camera
DIP switches
Receiver
DIP switches
Camera 3
USING THREE CAMERAS
Receiver
DIP switches
All Channels
(1,2,3)
Selected
Camera 2
Receiver
Camera 1
Camera
DIP switches
A
OUT
V
12V DC
BEEP
SELECT
VCA
Beeper Volume
Adjustment
Antenna
Camera Channel
Dip Switches
12V DC Power
Socket
CT220 VCA
Output
Audio Output
Video Output
Manual Mode
In “Manual Mode” individual cameras may be selected. Pressing the button
marked manual on the diagram below will select “Manual” and the LED indicator
will turn red.
Auto Mode
To select Auto mode press the “Auto” button marked on the diagram below and
the LED indicator will turn to green. The receiver will then switch automatically
between the available cameras. When a camera detects motion the Receiver will
display the picture from the camera for a few seconds, and the beeper will sound.
Adding Additional Cameras
You can have up to 3 cameras on your system. To add a camera you will need to
order a CA240, CA250, CA500, CA500B- Wireless Camera Accessory (Includes
Wireless Camera, Power Adapter and Fixing Kit). The CRP240 Rechargeable
Battery Pack is available for use with the CA240/CA250 Wireless Camera. The
CRP240 is NOT weatherproof and can only be used indoors. See Page10 for
accessories.
Dwell Time Setting (Time taken to switch between cameras)
To alter the dwell time press both of the buttons on the front of the unit
simultaneously. Each flash of the LED increases the dwell time by one second.
The dwell time is preset to 4 seconds, but can be adjusted between 2 to 30
seconds.
AUTO MANUAL
CAM1
CAM2
CAM3
Camera Number
LED Indicator
Auto Button
Manual Button
Mode LED
Indicator