If the product shows signs of damage, do not touch it, there is a risk of death from an elec-
tric shock! First, switch off the mains voltage to the mains socket to which the product is
connected (switch off the respective circuit breaker or remove the safety fuse; then switch
off the respective GFCI so that the mains socket is fully disconnected). You can then unplug
the mains plug from the mains socket. Dispose of the damaged product in an environmen-
tally friendly manner, stop using it. Replace it with an identical product.
Always lay the cables so that nobody can trip over or become entangled in them. This
poses a risk of injury.
The product must only be powered by a standard mains socket connected to the public
grid. Before plugging in the product, check that the voltage indicated on the product corre-
sponds to the voltage of your electricity supplier.
For safety reasons, disconnect the product from the mains socket during storms.
Ensure no liquids can spill on electrical appliances and never place any objects filled with
liquids near the device. Should liquid penetrate the device nonetheless, cut off the power
supply to the relevant mains socket (e.g. via the circuit breaker) and pull the mains plug
out of the mains socket. Discontinue use and take the product to a specialist repair centre.
Never use the product immediately after it has been taken from a cold room into to a warm
one. This may cause condensation to form, which can destroy the product. Furthermore,
it can cause a lethal electric shock! Allow the product to reach room temperature before
connecting it and putting it into use. This may take several hours.
Make sure the USB ports are not short-circuited.
Ensure there is sufficient air circulation when you operate the product. Never cover the
product.
Consult a technician if you are not sure how to use or connect the product, or if you have
concerns about safety.
If you have questions which remain unanswered by these operating instructions, contact
our technical support service or other technical personnel.
5.2 Connected devices
Always observe the safety information and operating instructions of any other devices which
are connected to the product.
Always switch off the USB device to be connected before connecting and disconnecting.
6 Operation
Connect the power plug to an appropriate power outlet.
Before connecting your USB device to one of the USB-A outputs or the USB-C™ output,
make sure it is switched off. You can charge up to three devices at the same time. In the
table below, you will find the available charging currents/charging powers.
Note: the USB-A (QC 3.0) operation is only possible if at least one of the two USB-A outputs
is free.
Port
Voltage
Current (max.)
Power (max.)
USB-C™ (PD 3.0)
5.0 V/DC
3.0 A
20.0 W
9.0 V/DC
2.22 A
12.0 V/DC
1.67 A
1x USB-A (QC 3.0)
5.0 V/DC
3.0 A
18.0 W
9.0 V/DC
2.0 A
12.0 V/DC
1.5 A
2x USB-A
5.0 V/DC
3.0 A
15.0 W (share)
Total power of all ports
38.0 W
The USB device will start to charge. Should you wish to operate the USB device, you may
turn it on now. Switch off the USB device before you unplug it from the product.
The outputs can be used to charge devices with different voltages (5 V, 9 V, 12 V) and USB
Power Delivery (PD 20 W).
Disconnect all connected USB devices from the USB charger after use. Disconnect the
USB charger from the car power socket after use.
7 Care and cleaning
1. Disconnect the product from the power supply.
2. Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these
may damage the case or cause the product to malfunction.
3. Do not immerse the product in water. Wipe the product with a dry cloth regularly.
Operating instructions
38 W USB Power Delivery charger
Item no. 2446229
1 Intended use
The product has two USB-A outputs and one USB-C™ (PD 3.0) output. The product is suitable
for charging and operating up to three USB devices at the same time. Power is supplied via a
standard household mains socket. The product is protected against short circuit and overload.
This product is intended for indoor use only. Do not use it outdoors. Contact with moisture (e.g.
in a bathroom) must be avoided under all circumstances.
For safety and approval purposes, do not rebuild and/or modify this product. Using the product
for purposes other than those described above may damage the product. In addition, improper
use can cause hazards such as short circuit, fire or electric shock. Read the operating instruc
-
tions carefully and store them in a safe place. Only make this product available to third parties
together with its operating instructions.
This product complies with statutory, national and European regulations. All company and pro-
duct names contained herein are trademarks of their respective owners. All rights reserved.
2 Delivery content
Charger
USB-C™ to USB-C™ cable (approx. 1 m)
Operating instructions
3 Up-to-date operating instructions
Download the latest operating instructions at
www.conrad.com/downloads
or scan the QR code
shown. Follow the instructions on the website.
4 Description of symbols
The symbol with the lightning in the triangle is used if there is a risk to your health,
e.g. due to an electric shock.
The symbol with an exclamation mark in a triangle is used to highlight important
information in these operating instructions. Always read this information carefully.
This symbol indicates that the power adapter has a protection class II. It is equipped
with reinforced or dual insulation between the mains circuit and the output voltage.
The product must only be installed and used in dry, indoor locations. It must not
become damp or wet, as this may cause a fatal electric shock!
This symbol indicates that the product meets the requirements for Level VI Energy
Efficiency.
5 Safety information
Read the operating instructions carefully and observe in particular the safety
instructions. If you do not follow the safety information and information on
proper handling in these operating instructions, we will assume no liability
for any resulting personal injury or damage to property. Such cases will inva-
lidate the warranty/guarantee.
5.1 General information
This product is not a toy. Keep it out of the reach of children and pets.
Do not leave packaging material lying around carelessly. It may become a dangerous
plaything for children.
Protect the product from extreme temperatures, direct sunlight, strong jolts, flammable ga
-
ses, vapours and solvents.
Never expose the product to any excessive mechanical stress.
If it is no longer possible to operate the product safely, stop using it and prevent unautho-
rised use. Safe operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stress.
Handle the product carefully. Jolts, impacts or a fall even from a low height may damage
the product.
The mains socket that the device is plugged into must be easily accessible.
Unplug the connected USB device from the product when you are not using it.
Electrical devices must never be plugged in or unplugged with wet hands.
