• For safety reasons, disconnect the product from the mains socket during storms.
•
Never pour liquids over electrical devices or place objects filled with liquid next to the product.
If liquid or an object does enter the interior of the device, power down the respective socket
(e.g. switch off the circuit breaker), and then remove the mains plug from the mains socket.
Discontinue use and take the product to a specialist repair centre.
• Never use the product immediately after it has been brought from a cold room into a warm
one. The condensate generated can possibly destroy the product. Furthermore, this could
cause a lethal electric shock! Allow the product to reach room temperature before connecting
it and putting it to use. This may take several hours.
• Make sure the USB ports are not short-circuited.
•
Ensure there is sufficient air circulation when you operate the product. Never cover the
product.
• Always switch off the USB device to be connected before connecting and disconnecting.
• Consult a technician if you are not sure how to use or connect the product, or if you have
concerns about safety.
•
Maintenance, modifications and repairs must be carried out by a technician or a specialist
repair centre.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Product overview
1 USB-C
TM
output
2 USB-A output (2 x)
3 LED operation lamp
4 Mains plug
1
3
2
4
Setup
• Connect the mains plug
(4)
to a suitable mains socket. The LED operation lamp
(3)
lights up.
• Connect a powered-off USB device to a USB-A port
(2)
or the USB-C
TM
port
(1)
. You can charge up to
three devices at the same time. Please note the available charging currents, see section "Technical data".
A total of 3 A are available.
• The USB device will start to charge. Should you wish to operate the USB device, you may turn it on now.
Turn off the USB device before removing the product from the mains socket.
• Disconnect all connected USB devices from the USB charger after use. Disconnect the USB charger from
the mains socket after use. The LED operation lamp goes out after a few seconds.
Care and cleaning
• Disconnect the USB charger from the mains socket and connected devices before cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may damage the
casing or cause the product to malfunction.
• Do not immerse the product in water or other liquids.
• Use a dry, lint-free cloth to clean the product.
Disposal
Electronic devices are recyclable waste and must not be placed in household waste. At the end
of its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to protection of the environment.
Technical data
Input voltage / current ........................... 100 – 240 V/AC, 50/60 Hz, 360 mA
Output voltage/current .......................... 5 V/DC, max. 3 A total, max. 2.4 A per USB output
Output power ........................................ max. 15 W
USB outputs ......................................... 2 x USB-A, 1 x USB-C
TM
Operating conditions ............................. 0 to +40 ºC, 20 – 85 % RH
Storage conditions ................................ -20 to +60 ºC, 10 – 90 % RH
Dimensions (L x W x H) ........................ 90 x 27 x 52 mm
Weight .................................................. approx. 74 g
Operating instructions
USB charger SPAS-3002C
Item No. 1712619
Intended use
The product has two USB-A outputs and one USB-C
TM
output. The product is suitable for charging and
operating up to three USB devices at the same time. Power is supplied via a standard household mains
socket. The product is protected against short circuit and overload.
This product is intended for indoor use only. Do not use it outdoors. Contact with moisture (e.g. in bathrooms)
must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. Using the product for
purposes other than those described above may damage the product. In addition, improper use can cause
hazards such as a short circuit, fire or electric shock. Read the instructions carefully and store them in a safe
place. Only make this product available to third parties together with its operating instructions.
This product complies with statutory, national and European regulations. All company and product names are
trademarks of their respective owners. All rights reserved.
Package contents
• USB charger
• Operating instructions
Up-to-date Operating Instructions
Download the up-to-date operating instructions at www.conrad.com/downloads or scan the QR code shown.
Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in a triangle indicates that there is a risk to your health, e.g. due to
an electric shock.
The symbol with an exclamation mark in a triangle is used to highlight important information in
these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on how to use the product.
Safety instructions
Read the operating instructions carefully and observe safety instructions. If you do not
follow the safety information and information on proper handling in these operating
instructions, we will assume no liability for any resulting personal injury or damage to
property. Such cases will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing
material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Never expose the product to mechanical stress.
• If it is no longer possible to operate the product safely, stop using it and prevent unauthorised
use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stress.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height may
damage the product.
• Always observe the safety information and operating instructions of any other devices which
are connected to the product.
• Unplug the connected USB device from the product when you are not using it.
• If the product shows signs of damage, do not touch it, there is a risk of death from an electric
shock! First, switch off the mains voltage to the socket to which the product is connected
(switch off at the corresponding circuit breaker or remove the safety fuse or switch off at
the corresponding RCD protective switch, so that the socket is fully disconnected). Only
then remove the product from the mains socket. Dispose of the damaged product in an
environmentally friendly manner, stop using it. Replace it with an identical product.
• The mains socket that the device is plugged into must be easily accessible.
• The product must only be powered by a standard mains socket connected to the public grid.
Before plugging in the product, check that the voltage indicated on the product corresponds to
the voltage of your electricity supplier.
• Electrical devices must never be plugged in or unplugged with wet hands.
• Never disconnect electrical equipment from the power outlet by the cable, always pull it out of
the mains socket by gripping surfaces provided for this purpose.
• When setting up the product, make sure that the cables are not pinched, kinked or damaged
by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled in them. This poses
a risk of injury.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication represents the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
*1712619_v1_0918_02_hk_m_en
