Instead of using the built-in battery, an external power cable (sold separately) can be used to
power the inverter with an external battery (11-15V). As some external batteries have larger
capacities, the inverter can work longer than that in using the built-in battery. You can purchase
external batteries with different capacities based on your requirements to prolong the continuous
service time of the inverter.
2. Connecting
to the
VOLTA V-385
1.
Turn “
Switch (04)”to “OFF”.
2.
Connect your device to the “AC Output Socket (02)”.
3.
Turn “
Switch (04)”to “ON”.
4.
Turn “Mode Selection (15)”to “Flash (flash mode)” or “Normal
(non-flash mode)”.
5.
Turn your device on. Now your device will draw power from the
inverter.
Power the modeling lamp off while using the inverter with monolights.
Otherwise,
the
battery unit of the inverter may run out of power within a short time.
When you turn the “
Switch (04)”
ON the inverter will beep and run a short
automatic detection. During the detection the LED indicators on the control panel will
change colors. The detection will last a few seconds. When it is done the unit will beep
and the “Status Indicator (07)” will turn green signalling the unit is ready to use
For
outdoor photography, the inverter can be used while plac
ed
inside
the
carrying case
to avoid any dust, sand, or water.
Before use, make sure to
open the “
Air Vent
Flap
(32)” on both sides of the
carrying case
and use the hook buckles to keep
them
opened.
DO NOT cover the “Air Inlet (12)”.
V. Connecting an External Storage Battery
1. Connecting an External Battery
1.
Take the VOLTA Inverter out of the carrying case.
2.
Check and ensure that the inverter is powered off.
3.
Interlock the “Power Input (16)”of the control unit and the “External
Power Output (22)” on the battery unit.
4.
Connect the “External Power Cable” to the battery unit. Ensure a
CORRECT positive and negative connection to the external
battery.
5.
Verify that preceding steps are properly performed, and then
power the inverter on.
2.1 external power cable
2.2 Standard of external power cables provided by
other manufacturers
(1) Allowing 100 A current
(2) No longer than 2m
2. Standard of External Power Cables
07
08
External power cable
(Sold Separately)
Summary of Contents for V-385
Page 1: ......
