INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
VOLT
®
Salty Dog Brass MR16 In-Grade Light
VWL-703-BBZ
Install/Replace Lamp
2
Install Fixture to Stake
5
Install Lens and Faceplate
3
–4–
–5–
Remove Faceplate and Lens
1
Install Stake
4
Unlock the screws and remove the
faceplate, gasket, and lens from the
housing.
Gasket
Faceplate
Lens
Housing
Screw
Insert lamp with correct wattage
and type marked on fixture
label.
CAUTION: Do not exceed
maximum wattage marked on
luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use a soft cloth to
handle lamp
.
MR16 Lamp
Socket
Place the lens, gasket and faceplate
back onto the housing. Secure them
with screws previously removed.
Hand tighten until snug, then use a
screwdriver to secure them in a star
pattern.
Screw
Housing
Lens
Faceplate
Gasket
Determine the desired location for
mounting the fixture. Hammer the
stake into the ground until flange of
stake is flush to grade. To avoid damage
to the stake, place a board on top of
the stake while hammering.
NOTE: If the ground is hard and the
stake is difficult to install, make a
crosscut in the ground using a flat
shovel before hammering the stake.
Board
Stake
Soil
Ground
Clear away an area in the ground at
the wireway slot on top of the stake.
Lay the luminaire pigtail into the
wireway slot and screw the fixture
onto the stake. Tighten until snug.
Fixture
Stake
Pigtail
Wireway Slot